Manual

Introduction

Getting started: your first circuit and the basic tools.

Open the app in any modern browser. Nothing to install: it runs on your device, on desktop or phone.

Your first circuit

1. Pick a gate from the component palette and click the canvas to place it.
2. Place two input pins and an output pin.
3. Choose the Wire tool and drag from one pin to another.
4. Switch to the Poke tool and click an input to toggle it. Wires update immediately.

Wire colors

Green is 0, bright green/red is 1, blue is Z (floating), and a red error mark means E (a conflict). The same colors are used on every guide on this site.